Today was an abbreviated session in the manufactory due to other pressing matters, but I did manage to machine the second bushing (breaking another drill; I'm beginning to suspect the - new - chuck isn't closing properly) and cut the copper piping to length. I need to trim them to get rid of the slight differences in length due to the inaccuracies of the pipe cutter. I'll probably do that with the table sander, but I might use a grindstone and do the job by hand. I'm too tired to decide right now.
I also noticed that the clear tubing has been scratched despite my excessive care not to do just that, dash it!
Photos will have to wait a little, I'm Afraid.
No comments:
Post a Comment